Change a Propane Tank
Forklifts fueled by propane are common inside warehouse environments. These forklifts have a propane mount situated at the back of the operator. These tanks have to be replaced periodically since they have limited lifespans. Forklift operators should utilize caution when handling propane tanks. Compressed gases are hazardous, particularly since the gas is flammable. Utilize care when replacing and removing propane tank to avoid injury.
1 If there is a need to change the propane tank, the first step is to stop the forklift, then turn the tank valve off. The lift truck must be left on until the engine dies. This procedure burns off the gas in the transfer hose which connects the engine and the tank. Prior to taking the next steps, put on the proper safety equipment, such as insulated gloves made of either neoprene or leather. It is very important for you to protect your skin from touching the compressed gas, which is extremely cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When you put in a new tank, reconnect the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 You could inspect for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to froth around the value. If this happens, inspect the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks around the valve area, and after that perform the leak checking procedure all over again. Persistent leaks mean that both the nut and connecting hose would need to be replaced. Nonetheless, if replacing the nut and hose still does not stop the leak, the tank must be replaced.
4 Finally, open the valve all the way to allow the gas to fill the connecting hose. After that you could start the forklift and resume operating.